DJ Hero Mechanical Keyboard Switch Conversion Kit

This is a set of parts to give your DJ Hero Turntable controller that signature mechanical keyboard click! This will involve basic soldering, and cutting a wire on the controller itself. It is completely repairable if you must go back, but your turntable will never again be completely "stock".

You'll need:
+ These 3D-Printed parts
+ A Phillip's head screwdriver
+ A DJ Hero turntable platter
(any of the actual platter pieces can be used on any console, it's only the crossfader that's console specific)
+ At least 3 low-profile choc keyboard switches of your preferred variety with FLAT TOPS (NOT the stem tops!)
+ A soldering iron (This is a fantastic project to try if you're just starting out soldering!)
+ Solder
+ Some electrical wire, just to make the soldering easier
+ Scissors or similar cutting tools

Method:
1) Detach the platter from the crossfader on your DJ Hero controller, and set the crossfader aside.

2) Unscrew all of the screws on the feet of the DJ Hero con