Slicer Discord
DJI Battery counter/logger – 3D-Druckmodell von Thingiverse Thingiverse

DJI Battery counter/logger

von wumfi
0 Downloads
0 Likes
0 Makes
Zum Modell
It's always advisable to rotate your RC batteries. especially if they are the smart ones. This is a simple little thing to keep tabs on what battery to use next. It uses raised dots to represent 1, 2 and 3.

Just move the peg to whatever fits your battery strategy. Personally, I just use it to tell me which battery should be used next, but you can use it however you see fit.

The peg is quite a snug fit, and is a bit of a challenge to get printed accurately. If you can't get it right, then you can scale up or down a few %age as needed.

I've also added a loop so that it can be attached to something in/on your bag.
Quelle
Thingiverse
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
ABS
Software
Cura, PrusaSlicer o. Ä.
Gleicher Designer, mehr Plattformen

wumfi veröffentlicht auch auf

4 zusätzliche Modelle auf 2 weiteren Plattformen

Verifiziert durch übereinstimmende Modelltitel über Plattformen hinweg.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen