MakerWorld
RC
Model downloaden
DJI FPV Camera Shell
3
Downloads
2
Likes
0
Makes
Middle shell for the original DJI camera from the first DJI Air Unit. Made this because the screw holes on my one has been stripped. Tested in PLA+ and fits perfectly, mounting screws have a tight fit on the first few use but might become loose if constantly putting screws on and off. Please note that the original metal housing acts as a heatsink to the main chip on the PCB and you won't have that when using this. Not sure if it matters as other cameras similar to this don't need them. Use at your own risk.
ryanort publiceert ook op
1 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!