Thingiverse
DJI FPV with TBS Source 2
by Stefan3D
15
Downloads
3
Likes
0
Makes
Camera Holder & Crash Protection for the DJI FPV Camera on a TBS Source Two.
Use 35mm Standoffs (Frame comes with 30mm) to allow the Air Unit to be placed on top of the stack. The place between Air Unit and Camera is tight, so I decided to put the camera rather low and the air unit hight. Cam Holder is designed to be not visible in the FoV.
Result is a very compact racer with DJI FPV - and yes, props are in the FoV as usual with racers.
Use 35mm Standoffs (Frame comes with 30mm) to allow the Air Unit to be placed on top of the stack. The place between Air Unit and Camera is tight, so I decided to put the camera rather low and the air unit hight. Cam Holder is designed to be not visible in the FoV.
Result is a very compact racer with DJI FPV - and yes, props are in the FoV as usual with racers.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!