Thingiverse
DJI Goggles SMA Tool
door FLOwFPV
16
Downloads
13
Likes
0
Makes
I did this tool (PLA) because the SMA connector of my DJI goggles was getting loose.
Go very slowly when you use it and double check that the SMA is not turning when you do it (to not break the pigtail antenna cable).
I added the .step if your printer have not the same calibration of mine, maybe you will have to make some adjustment.
Feel free to leave a comment!
https://www.youtube.com/channel/UCkCDziM8F1IDWy09MCM24TQ
https://www.facebook.com/FLOwFPV
Go very slowly when you use it and double check that the SMA is not turning when you do it (to not break the pigtail antenna cable).
I added the .step if your printer have not the same calibration of mine, maybe you will have to make some adjustment.
Feel free to leave a comment!
https://www.youtube.com/channel/UCkCDziM8F1IDWy09MCM24TQ
https://www.facebook.com/FLOwFPV
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!