Thingiverse
DJI Ground Unit
by macourteau
14
Downloads
8
Likes
0
Makes
This is a remix of a few great things. It's a holder for a DJI Air Unit, for ground RC applications. A few of the changes from the originals:
* The fit of the air unit is tighter;
* There are countersunk holes for M3 screws to mount the holder;
* The antennas are 90 degrees apart;
* There is a channel to feed the electrical wires through (and a cable puller to pull the cables through the channel);
* There is a slot for a battery and a short strap;
* The 25mm fan holder's side hole is large enough for a PH2.0 connector.
(shown in the photos, mounted on a Tarmo4 with a modified battery box)
* The fit of the air unit is tighter;
* There are countersunk holes for M3 screws to mount the holder;
* The antennas are 90 degrees apart;
* There is a channel to feed the electrical wires through (and a cable puller to pull the cables through the channel);
* There is a slot for a battery and a short strap;
* The 25mm fan holder's side hole is large enough for a PH2.0 connector.
(shown in the photos, mounted on a Tarmo4 with a modified battery box)
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
