Thingiverse
DJI Mavic controller Bike Mount for Riser Bar
by MettaUK
17
Downloads
16
Likes
2
Makes
Remixed, basically hacked the original to turn it 90 degrees to mount the controller on the riser bar for ease of use and take up less space on a limited width handlebar.
Also remixed and made a few adjustments for hex bolts rather than cap end bolts, knobs are also a little longer for ease of grip.
BOM
2 x M4 20mm hex bolts
1 x M4 35mm hex bolt
3 x M4 locking (Nyloc) nuts
controller_mount_v3-Conroller_mount_Meshed.stl is unchanged.
Printing
Print it strong, minimum 4 perimeters, 1.2mm top and bottom and 25% infill as an absolute minimum, depending on material used.. PETG or PET CF or Nylon 12 CF suggested!
Also remixed and made a few adjustments for hex bolts rather than cap end bolts, knobs are also a little longer for ease of grip.
BOM
2 x M4 20mm hex bolts
1 x M4 35mm hex bolt
3 x M4 locking (Nyloc) nuts
controller_mount_v3-Conroller_mount_Meshed.stl is unchanged.
Printing
Print it strong, minimum 4 perimeters, 1.2mm top and bottom and 25% infill as an absolute minimum, depending on material used.. PETG or PET CF or Nylon 12 CF suggested!
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!