Thingiverse
DJI Mavic Pro Case
di izezti
112
Download
79
Likes
0
Makes
5mm thick case with slip fit lid and room to add felt liner if you so choose. Embossed DJI and engraved Mavic Pro.
To get a smooth top w/ the font and not deal with supports in the letters I printed this right side up w/ 3% supports... once the printing reached a Z height of 30.15mm I paused and added a layer of blue tape. You can of course just use a higher density of supports but I was being cheap with the filament and wanted to cut down time as much as possible! :) (vs. 15% supports would add 7 hours of print time and 90g of filament on 0.15 layer resolution)
To get a smooth top w/ the font and not deal with supports in the letters I printed this right side up w/ 3% supports... once the printing reached a Z height of 30.15mm I paused and added a layer of blue tape. You can of course just use a higher density of supports but I was being cheap with the filament and wanted to cut down time as much as possible! :) (vs. 15% supports would add 7 hours of print time and 90g of filament on 0.15 layer resolution)
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
