Thingiverse
DJI Mavic Pro - Light system
by 8link
220
Downloads
175
Likes
0
Makes
DIY light system for DJI Mavic Pro drone designed in Sketchup. It is based on two small 1s flashlights T6 Cree, two 1s 600 mAh LiPol batteries and two chargers based on TP4056 and DW-01P chips.
TP4056 is used to charge batteries through USB port and DW-01P is keeping them safe from overcharge and over discharge.
Printed with TPU with 25% infill. You need to print most of the thing horizontally, refer to CURA screen shot. Also remember to print "holder" two times but one needs to be mirrored.
Tested in flight and works great :) If you have any question feel free to ask.
TP4056 is used to charge batteries through USB port and DW-01P is keeping them safe from overcharge and over discharge.
Printed with TPU with 25% infill. You need to print most of the thing horizontally, refer to CURA screen shot. Also remember to print "holder" two times but one needs to be mirrored.
Tested in flight and works great :) If you have any question feel free to ask.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
