Thingiverse
DJI Phantom 4 Motor Cap
by jonbunker
76
Downloads
54
Likes
1
Makes
From a request for a motor cap for DJI Phantom 4- push fit cap.
I have compromised between strength and printability- it does seem to fit in the Phantom 4 case, but is very tight! There are lugs on the inside of the main ring to hold it in place if your printer has a fine setting.
Printed on a very old Afinia Up! (65minutes)
I have compromised between strength and printability- it does seem to fit in the Phantom 4 case, but is very tight! There are lugs on the inside of the main ring to hold it in place if your printer has a fine setting.
Printed on a very old Afinia Up! (65minutes)
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!