Slicer Discord
DJI Phantom 4 Pro - FPV Racing Version – 3D-Druckmodell von Thingiverse Thingiverse

DJI Phantom 4 Pro - FPV Racing Version

von rasor
12 Downloads
12 Likes
0 Makes
Zum Modell
DJI Phantom 4 Pro - FPV Racing Version
I was lucky enough to get a DJI Phantom 4 Pro display model given to me; it's basically the shell, motors (with no wires), camera gimbal + motors (and no camera) so I decided to FPV it up and make a 6S Racing beast.

There's plenty of space inside the arms for a 30a esc's and room enough for a 30x30mm stack above the camera gimbal.

The display model came with working brushless gimbal motors, but I didn't want to ruin these (as I could either sell them or re-use them elsewhere) so I needed to lock up the gimbal at around 30 degrees, make a mount for a runcam mini swift and make a few mounts for a FC stack.

If you're familiar with building racing quads then this should be no challenge for you.

I used up "spares" to build this, may be tempted in the future to put GPS on it and turn it into a long range quad. I wanted the changes to be as discreet as possible and to raise a few eyebrows when powerlooping a P4 through a fpv gate...

htt
Quelle
Thingiverse
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA
Mindest-Druckbett
30 mm (Klein)
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen