Thingiverse
DJI RC Motion 1/2 base
by Mkz
6
Downloads
15
Likes
0
Makes
This is a joystickbase for DJI RC Motion controller 1 and 2. Print with 40% gyroid infill and support. Use 2 wide rubber bands for centering the stick.
Update version 2
This is the grey one with gaiter and grip.
Use 40% gyroid infill and tree support. Attach stick to middle part first and loop rubber bands to the stick. Use a temporary ziptie to pull the rubber bands through the base. Optionally print the gaiter with TPU and put it on the base before attaching the middle part to the base.
Update version 2
This is the grey one with gaiter and grip.
Use 40% gyroid infill and tree support. Attach stick to middle part first and loop rubber bands to the stick. Use a temporary ziptie to pull the rubber bands through the base. Optionally print the gaiter with TPU and put it on the base before attaching the middle part to the base.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
