DK Riser for BambuLab X1

When I made / remixed my first Riser, it was out of personal necessity… because the built-in LED in BambuLab was not sufficient… and that Low profile design turned out to be quite popular. Since then, a couple of users Qiao112 and Dan Ljungström encourage me to do the next version that also has a vent on it… they showed me a design from another desinger… which is very good… but I personally like it to be not as tall… So through the rabbit hole I went… gone thru several design ideas… throw away most of them, starting over and over… until I came up with something that I personally like… So here it is… still similar to the first design, it has a TPU Bed/ Light Shield on top but I made several modification from the original design, recognizing issues that was inherent from the first design. The first design, I angled the LED 60 degrees downward, the problem is, if we do not want to cut the LED strips and do some soldering at the corners, you have to bend the LED strips, it will be very har