Thingiverse
DLG Modular Wall Mount (Discus Launch Glider)
von agibson2
22
Downloads
20
Likes
0
Makes
This is a wall mount design that I created using Fusion 360 to hold DLGs (Discus hand Launch Gliders). I loosely based it on a cardboard DLG mount that I designed years ago. It has modules so that you can have 1 or multiple DLGs on a single wall mount. Each of the 3 modules that I include support a DLG at different angles. Centered so that the DLG is straight up and down, leaning left, and leaning right (referenced from standing and facing the wall). The purpose of the different angles is so that the tails don't hit each other.
I have used up to 3 modules to support 3 DLGs on a single wall mount. You should be very cautious though because if your print is under-extruded or flawed in some other way, the strength of the mount that you print could be weaker. Make sure to test it with some kind of weight way over the maximum that you plan to use before putting your expensive DLGs on it.
I am not using any felt or anything on the mount and haven't seen any wear on the leading e
I have used up to 3 modules to support 3 DLGs on a single wall mount. You should be very cautious though because if your print is under-extruded or flawed in some other way, the strength of the mount that you print could be weaker. Make sure to test it with some kind of weight way over the maximum that you plan to use before putting your expensive DLGs on it.
I am not using any felt or anything on the mount and haven't seen any wear on the leading e
agibson2 veröffentlicht auch auf
22 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!