DMT Dia-Sharp 8" Stone sharpening jigs

This is a sharpening stone holder (just fits on my Prusa Mk2 print bed if I rotate around 45 degrees) and some guided angle slides to help with knife sharpening. Most kitchen knifes are sharpened at 17 degrees and most general purpose knifes are sharpened at 20 degrees. The guides are designed to slide up and down the stone holder with the knife resting on them and the edge on the sharpening stone.

The Vertical Stone Holder was designed for flattening the edge of scraper tool for woodworker prior to burnishing it. It is unlikely you will need this part, so don't print this unless you are certain you have a use for it.

Here are the sharpening stones I used for this:
https://www.sharpeningsupplies.com/DMT-8-Dia-Sharp-Diamond-Stone-P7C3.aspx

I printed this in PLA with standard slicer settings.