Thingiverse
DNA75/200/250
door UKDTweak
20
Downloads
14
Likes
1
Makes
This is my third DNA design, it requires No magnets for the door, the model should be 85/60/26, but i use Windows 3D Builder as sometimes it changes the sizes slightly, so double check before printing.
I have included pictures to show the case with a dual 18650 sled and the Stealthvape DNA200/75 mount kit fitted and ready.
I have printed this twice myself, though only printed the body twice and the door once, it required a bit of sanding and the three screw holes in the face plate are only 1mm, so these will need drilled out to 1.5mm for the Stealthvape Mount kits screw.
I have included pictures to show the case with a dual 18650 sled and the Stealthvape DNA200/75 mount kit fitted and ready.
I have printed this twice myself, though only printed the body twice and the door once, it required a bit of sanding and the three screw holes in the face plate are only 1mm, so these will need drilled out to 1.5mm for the Stealthvape Mount kits screw.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
