Thingiverse
DnD Boat
von Galror
28
Downloads
48
Likes
0
Makes
I made those beam for my DnD campaign that needed a boat, couldn't find any model for something similar.
**Added a ladder, no need for support if printed with the front side down.
You need to print 1 rear, 1 front and 4 sides.
For the floors, I used some craft foam board from the dollar store that are 5-6mm or 1/4" thick.
You can find the layout for the floors in the PDF
The full beam are a bit to tall for fighting creature in water, I prefer the shorter one.
**Added a ladder, no need for support if printed with the front side down.
You need to print 1 rear, 1 front and 4 sides.
For the floors, I used some craft foam board from the dollar store that are 5-6mm or 1/4" thick.
You can find the layout for the floors in the PDF
The full beam are a bit to tall for fighting creature in water, I prefer the shorter one.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
