Thingiverse
DND Flying Support Base Stand
von bo14in
95
Downloads
75
Likes
0
Makes
This is a base to set DND figures on to represent flying creatures/players. I recommend using 20-50 infill to help with support strength. Print it on its side with the support stick down to lessen the amount of supports needed. Let me know if you use it.
I made this so that you can put a figure on top to show that it is flying while still being able to put a creature under it on the lower part so things can share a single spot easier.
I made this so that you can put a figure on top to show that it is flying while still being able to put a creature under it on the lower part so things can share a single spot easier.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!