Slicer Discord
DnD Wall Collection – 3D-printbaar model van Thingiverse Thingiverse

DnD Wall Collection

11 Downloads
18 Likes
0 Makes
Model downloaden
These are simple modular walls for creating dungeons.
The walls are connected by magnets, so there is a place for a round-shaped magnet (6mm * 2 mm) on all the walls.
Wall Features: Each part of the wall is a section that is 2.5 cm square or 5 ft long, which allows you to recreate the dungeon map very accurately.
I also prepared walls of different lengths, in my opinion, this combination allows you to best simulate a dungeon:

wall 5 feet (2.5cm)
wall 10 feet (5 cm)
wall 15 feet (7.5 cm)
wall 20 feet (10 cm) long
Inner corner 5*5ft (2.5*2.5cm)
Outer corner 5*5ft (2.5*2.5cm)
Internal dead end 5*5 feet (2.5*2.5cm)
others

If you need large dead ends, you can always connect the corners and walls together.

I am also planning to make a door that will be suitable for this wall and can also open, I also plan to make an arch for beauty. A little later, I plan to modify the walls by pressing different structures on them (stone, brick, wood), and if possible create a floor an
Bron
Thingiverse
Wat je nodig hebt om te printen: Gevorderd Lage betrouwbaarheid
Waarom?
uitgebreide nabewerking
Hardware nodig
Supports 1/3
Montage 2/3
Instellingen 1/3
Bedgrootte 0/3
Nabewerking 2/3
Printer
FDM / FFF
Bestandsformaat
STL
Materiaal
PLA, Wood PLA
Nabewerking
Lijmen, Hardware
Software
Cura, PrusaSlicer of vergelijkbaar
Nog geen beoordelingen
Nog geen reacties – wees de eerste!

Vergelijkbare modellen

6 Suggesties
Feed Blog Slicer Kostenrekenmachine Zoeken op afbeelding Indienen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Toevoegen aan collectie