DNX Mounting System

::::::::::::::::ENGLISH::::::::::::::::

Update 6: Added Telescopic system.
There are 4 variants in 3 sizes.
Variant 1: with hole lockers and main lock for avoid interior part to get out easily
Variant 2: without hole lockers
Variant 3: without main lock
Variant 4; without hole lockers and main lock.

Use standard rects to fit into this system to create telescopic variants for your mounts.

Update 5: Added Ball/Joint system.
This system was generated for light devices such small cameras, etc.
the system uses the holes on the base pieces (Rects) for install the balls.
You must use a screw for adjust the strenght of the ball support.

I recommend to print these parts with 100% infill, to make it strong.

Update 4: Camera Mount Part and Screw.
I recommend to use the original screw from camera mount, but if you want to print this, set 100% infill for gain strenght.

There are two screws version, normal and short, for allow to chose what you prefer to use.

Update3: A