Thingiverse
Dog spinner
von pauerbuk
59
Downloads
49
Likes
1
Makes
If you are a dog lovers, like me, this spinner is for you! ;-)
Designed with bones profile in mind, It uses a single bearing, therefore is very inexpensive; nevertheless the weight is well distributed, and the time of spinning lasts long.
The bearing used are standard skateboard 608, 22mm in diameter, and nuts are 8MA, 13mm hexagon; no need for glue, normally.
**The caps used for the bearing in the simple spinner without covers are not my design; I have used this one:
https://www.thingiverse.com/thing:1848330
For the cover version, a slighty modified version it's enclosed.
Enjoy!
Designed with bones profile in mind, It uses a single bearing, therefore is very inexpensive; nevertheless the weight is well distributed, and the time of spinning lasts long.
The bearing used are standard skateboard 608, 22mm in diameter, and nuts are 8MA, 13mm hexagon; no need for glue, normally.
**The caps used for the bearing in the simple spinner without covers are not my design; I have used this one:
https://www.thingiverse.com/thing:1848330
For the cover version, a slighty modified version it's enclosed.
Enjoy!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
