Dog Tag Magnet

This is a Dog Tag Magnet.

These are only the finish parts of it that i used to make it.

Soo, how i made it ?
I used a silicone Form and filled it with a thin layer of epoxy.
->than let it dry completly.
leave it inside the form.

My next step was to print some letters with my glowing Filament.
-> Done

Now you have to put the letters inside the form.
Pay Attention !
You have to add them mirror sided because you will turn the piece at the end to see the letters from the frontside.
this works best with a tweezer. ( i also made one to print out - check my profile ;) )

So everything is in place...
Now add the second layer of Epoxy.
If you like you can mix it with a little bit of color.
-> let it dry again.

After 24hrs it is normally hard enough to take out.
Next step is to add THIS PRINT HERE around the piece.

As the last step you need a third layer of epoxy where you can put the magnet inside.

This is just an example of how i made it.

This is a Tablet