Thingiverse
(Dog) Wheelchair Hook
von uZoOne
3
Downloads
1
Likes
0
Makes
Our dog Vanillo had two herniated discs and since then his hind paws are paralyzed.
We had a wheelchair built for him but his leash was always falling in the space between the wheelchair and wheels when went for a walk.
I remixed the Wheelchair bike lamp holder by Kerze591 and just added a little hook so the leash will be prevented to fall all the way down. I adjusted it so that it fits for the diameter of 16mm.
After printing we got him an additional flexible leash so he can walk further from us and I discovered that we just can hook it with this setup.
The rear part is from the original file just adjusted to the size needed.
I printed it upside down with supports.
We had a wheelchair built for him but his leash was always falling in the space between the wheelchair and wheels when went for a walk.
I remixed the Wheelchair bike lamp holder by Kerze591 and just added a little hook so the leash will be prevented to fall all the way down. I adjusted it so that it fits for the diameter of 16mm.
After printing we got him an additional flexible leash so he can walk further from us and I discovered that we just can hook it with this setup.
The rear part is from the original file just adjusted to the size needed.
I printed it upside down with supports.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!