Dogecoin

If you want to make a donation to me, please send me doge:
D66hCBwfZRu7ANqdVFcjz8MVCXvhTQtYhX

Designed so it can be easily drag-n-dropped into a slicer (or at least Cura, which is what I use) to allow printing of a 56mm Dogecoin.

This download includes the following:
Dogecoin.stl
Dogecoin (without circuit).stl
Dogecoin Side A.stl
Dogecoin Side A (without circuit).stl
Dogecoin Side B.stl

If you want to print with supports, go ahead, but I found the best results to be printing the halves of the coin separately, and then glue them together with superglue. It is a clean split and they fit together nicely.

I've included a "without circuit" version of the Side A and the Dogecoin itself, because at a coin size (56mm) the circuits don't print too well on a 0.4mm nozzle. If you want to lower your nozzle size, I'm sure it would work better, but otherwise I have included these alternatives. That said, if you print big enough, all of the coin's lines are extruded cleanly and shou