Thingiverse
Dogtag Protector
di Smaxx
3
Download
5
Likes
0
Makes
A very quick and simple proof of concept for a dogtag protector. We used cheap rubber ones before to reduce noise and avoid injuries, but they'd typically become brittle, tear, or cut themselves within weeks. I actually wanted to print these with flexible filament, but since I've only got PLA right now, still gave it a go and the result works rather well.
**The STL is designed for a 50x28x0.8mm dogtag.** One side is open so you can slide the dogtag in, even if it's PLA.
Make sure to print it upright and with supports, Otherwise Slic3r wouldn't create the top layer for me (open for suggestions). I also used a small brim just to be sure.
There's no cleanup required, but based on the actual dogtag size and your printer's accuracy, you might have to increase the opening a tiny bit (it was a very tight fit for me)..
**The STL is designed for a 50x28x0.8mm dogtag.** One side is open so you can slide the dogtag in, even if it's PLA.
Make sure to print it upright and with supports, Otherwise Slic3r wouldn't create the top layer for me (open for suggestions). I also used a small brim just to be sure.
There's no cleanup required, but based on the actual dogtag size and your printer's accuracy, you might have to increase the opening a tiny bit (it was a very tight fit for me)..
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!