Dolce Gusto capsule holder- improved version

This is an improved version of Dolce Gusto capsule holder: https://www.thingiverse.com/thing:2847560

## You will need:
- 1x base (0.20 layer height or above)
- 1x ring
- 6x capsule holder

## Depending on the total height you want:
- 220 mm height total:
- 1x slider with pins (110 mm)
- 1x slider with cover (110 mm)
- 200 mm height total (one piece, less gluing needed):
- 1x slider large with cover

## Assembly instructions:
- place base on the bottom
- add ring on the base
- in case you have 2 slider parts, glue them together
- set slider part(s) upside down and glue all capsule holders
- attach the glued part on the base, it should fit perfectly and rotate freely

## Recommended layer height is 0.2, except for the base part which can go higher.