Dome Wall Lamp

I designed this lamp for use in the bathroom for diaper changes in the middle of the night instead of turning on the bright one in the roof. In my case its just a rule in Home Assistant of which light to turn on before or after bedtime when movement is detected. Of course your application may be something completely different and may not be connected to any home automation at all. In my case I used ESPHome to "program" and connect the light to Home Assistant.
**They are versions with and without text**

# Needed parts
You will need:
- ESP8266 / ESP32 / Arduino small enough to fit in the base. I used a nodemcu (ESP8266) called D1 mini.
- Neopixel ring with an outer diameter of ~68-70mm (two common sizes)
- An usb cable and wall adapter (or alternative power source)

# Wiring
If you choose to use an NodeMCU D1 Mini as I did the connections are the following.

NodeMCU | Neopixel Ring
- | -
GPIO3 / rx | DIN
GND | GND
5V | 5V

# Print
The only part in need of any special