Dominion Resource Holder

I loved the original concept, but not all of the sets I had were designed. So I decided to make my own with a few added features. Then it was easy enough to make them for already sets:

1. I increased the width of the slots from 3.75mm to 4mm to allow for easier inserting and removing of cards. If folks really like this design, I can make them even bigger for sleeved cards
2. I rounded the edges of all the slots to make inserting the cards easier.
3. I reduced the height of the holder from 52mm to 30mm. This greatly reduces print time and filament used, while still keeping the cards secure.

Side note: In the last photo you may notice there are too many slots. Rest assured I have fixed it and the file is correct. I was just too lazy to reprint it :p