Donkey Kong Hueforge

This print can be done with a single AMS unit. Instead of swapping to orange at layer 19 (either assign them to the same AMS slot or change in slicer)swap to Beige and let it continue. Assign Black and White to the same AMS slot and swap the Black with the White when the black baselayer finishes. Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mmThe Model is 200x200mm in sizeYou may print at higher layer heights below the Min Depth of 0.48mmThe Max Depth is 2.4mm and the Actual Depth is 2.3mmFilaments Used: PLA Kexcelled Black Transmission Distance: 0.2 PLA PolyTerra Earth Brown Transmission Distance: 0.3 PLA PolyLite Pro Metallic Red Transmission Distance: 0.5 PLA Kingroon Orange Transmission Distance: 4.6 PLA BambuLab Basic Beige Transmission Distance: 8 PLA PolyLite Pro Cold White Transmission Distance: 0.5This print uses 6 unique filamentsSwap Instructions: Start with Black At layer #9 (0.8mm) swap to Earth Brown At layer #12 (1.04mm) swap to Metallic Re