donut cutter

i wanted to make donuts but i didnt have anything i was satisfied cutting them with so i designed one in solidworks, i designed it with a chamfer around the bottom so it would cut easier. and a curve on top for comfortable holding and holes in the top for easy release of the donuts.

I used the dimensions I found on the internet
Large cutter: 3 1/5" or 82 mm diameter
Hole cutter: 1" or 25 mm diameter
Height: 1 2/5" or 35 mm

This cutter is designed to be durable and comfortable to hold and to be easy in use.

ther are 3 models, because i fount that i needed to add a layer on the bottom to make it stick. i personally used the file with the full brim.

For the models with a brim in the design you'll need to set the initial layer height to 0.2 mm and for slicing software i used cura, i printed it cut side down, but you could also try to print it curve side down.

I also added the original solidworks file in case you want to change something.

It requires some sanding after