Thingiverse
Doom 4 Helmet Visor Buck
von scarr69
19
Downloads
16
Likes
0
Makes
Vacuum Forming Buck created from Jace1969's file.
This is for the Doom 4 Helmet NOT the Doom Eternal (See Picture)
To get a good form this will need sanding/priming and painting
20% In Fill on a CR10, no supports needed Printed in PLA+ but if you want to print more than 1 or 2 then you'll need a more heat resistant filament
This is for the Doom 4 Helmet NOT the Doom Eternal (See Picture)
To get a good form this will need sanding/priming and painting
20% In Fill on a CR10, no supports needed Printed in PLA+ but if you want to print more than 1 or 2 then you'll need a more heat resistant filament
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!