Thingiverse
DOOM Eternal Crucible
von VectorWorks
1
Downloads
1
Likes
0
Makes
The model is significantly shorter than the in-game Crucible (~60-65 in), coming in at ~36 in. I'm just not as big as the Doomslayer.
This model is fully 3D-printable and has a threaded handle, but the other parts, like the blade and the side extenders (not sure what they're called), are glued with PVA glue.
The blade is too big to print in one piece (depending on the printer used), so it will need to be cut in the slicer.
When printing, each piece is labeled with a number. Follow the image guide above for how to assemble it, just like my other models.
Infill: 15% (Can be higher depending on how strong you want it)
Material: PLA
Supports: Depending on how they are sliced
Brim: Not required, but recommended
This model is fully 3D-printable and has a threaded handle, but the other parts, like the blade and the side extenders (not sure what they're called), are glued with PVA glue.
The blade is too big to print in one piece (depending on the printer used), so it will need to be cut in the slicer.
When printing, each piece is labeled with a number. Follow the image guide above for how to assemble it, just like my other models.
Infill: 15% (Can be higher depending on how strong you want it)
Material: PLA
Supports: Depending on how they are sliced
Brim: Not required, but recommended
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
