Door for NOVA3D Elfin2 printer

I got this NOVA3D Elfin2 Printer a few weeks ago and quickly decided it needed a door.

This is not an easy project. This cover is a curved, tapered triangle. I thought carefully about it for a couple days before actually starting. There were still a few surprises, but nothing that couldn't be overcome.

There are a lot of ways to make a door. It could tilt up and back, left to right, it could be larger or perhaps smaller. This design works for me. Everything inside is accessible. The lift-off hinges allow easy door removal. The entire cover can be unclamped and removed if need be.

I wanted straight, thin cuts. The cover is very tough stuff, probably Lexan (polycarbonate), and my hot-knife couldn't cut it. So, I used the Dremel and one of those small, thin diamond wheels. Lay it all out, stretch masking tape, draw straight lines, and free-hand it.

The remainder of the cover was just sitting there, loose and unstable, so I clamped it down.

Once the opening was cut, the h