Door holder latch - replacement handle version

EDIT: - please use the updated version which has an improved design to remove any rattling and a more ergonomic handle: https://makerworld.com/en/models/703921#profileId-633706 --------------------------------------------------------------------------------------------------------------------- This is a version of my popular “Door holder handle latch” which, rather than snap on the stock door handle, replaces it entirely using the two screws that hold the original door handle on. It takes less than 2 minutes to fit. This is great for people where the tolerances of the original design were too tight on their stock handle. The Bambu Wiki recommends you keep your door and lid open when printing in low-temperature filaments such as PLA and TPU, however, the door can then swing about and is liable to be knocked further open risking damage or closed by mistake. It also swings about when printing fast which cannot help print quality. By securely latching the door open this simple and quick pr