Thingiverse
Door lock installation jig/template
door Abcdang
10
Downloads
6
Likes
0
Makes
Door lock installation jig.
Setup for a 44mm thick door, standard 1" and 2 1/8" lock hole, 2 3/8" offset (60mm)
Just clamp it to the door and go at it. This version, the offset was slightly tight, so may need to increase just a bit. not sure if it was my printer or design.
Before drilling, run the hole saws through the part a few times to round it out. Just like you have to do with the ones that cost $30...
updated file to match 60mm offset 8/31
Setup for a 44mm thick door, standard 1" and 2 1/8" lock hole, 2 3/8" offset (60mm)
Just clamp it to the door and go at it. This version, the offset was slightly tight, so may need to increase just a bit. not sure if it was my printer or design.
Before drilling, run the hole saws through the part a few times to round it out. Just like you have to do with the ones that cost $30...
updated file to match 60mm offset 8/31
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!