Thingiverse
door magnet
von Indianin666
9
Downloads
4
Likes
0
Makes
Door holding magnet.
10x3mm round magnets and two M3 15mm screws with nuts are needed to make them.
In my case spacers were necessary. V.2 was enlarged by 7mm to make it fit without pads.
10x3mm round magnets and two M3 15mm screws with nuts are needed to make them.
In my case spacers were necessary. V.2 was enlarged by 7mm to make it fit without pads.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
