Slicer Discord
Door nob wing lever – 3D-printbaar model van Thingiverse Thingiverse

Door nob wing lever

door shink
6 Downloads
8 Likes
0 Makes
Model downloaden
A wing-like lever for opening the door without touching it.
It may also be useful for people who have difficulty grabbing a round knob.


You can use your wrist or lower arm to turn the knob to open the door instead of the palm of your hand.
The area is set a little wider so that it can be used not only for pushing but also for pulling.

Attach it to the round doorknob with M4 cap bolts.
Please note that it may crack if overtightened.
There is little friction between stainless steel and plastic.
If necessary, insert a small piece of double-sided tape into the gap.

When installing on the "push" side, adjust the angle so that it does not hit the door frame.

See the attached drawing for applicable doorknobs.
If it is a similar figure, use the slicer function to adjust the size.

M4 x 15 Cap screw ... 4
M4 nut ... 4
Double sided Adhessive tape ... if needed

I hope this wing will lead to your peace of mind.
Masks, hand washing, alcohol disinfection and social d
Bron
Thingiverse
Wat je nodig hebt om te printen: Gemiddeld Lage betrouwbaarheid
Eendelig Hardware nodig
Supports 1/3
Montage 0/3
Instellingen 1/3
Bedgrootte 0/3
Nabewerking 1/3
Printer
FDM / FFF
Bestandsformaat
STL
Materiaal
PLA
Nabewerking
Hardware
Software
Cura, PrusaSlicer of vergelijkbaar
Zelfde ontwerper, meer platforms

shink publiceert ook op

2 extra modellen op 1 andere platforms

Geverifieerd door overeenkomende modeltitels op platforms.
Nog geen beoordelingen
Nog geen reacties – wees de eerste!
Feed Blog Slicer Kostenrekenmachine Zoeken op afbeelding Indienen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Toevoegen aan collectie