Slicer Discord
Door Pusher – 3D-Druckmodell von Thingiverse Thingiverse

Door Pusher

von l1zardcat
0 Downloads
1 Likes
0 Makes
Zum Modell
Door knobs are dirty. This two part print will help you open all sorts of doors with a minimum of touching.

Round door knobs can be gripped in the ring.

Lever handles can be gripped and pulled with the ring, or pushed with the flat front end, using the tab to minimize slipping.

Push-out exit doors can be pushed with the flat edge at the front.

I added gaffer tape on the inside of the ring and on the flat front. Helps with grip, can be discarded in lieu of cleaning.

You'll need a M3x30 screw and nut for the hinge.
Quelle
Thingiverse
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Einteilig Hardware nötig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 1/3
Drucker
FDM / FFF
Dateiformat
STL
Material
Mindest-Druckbett
50 mm (Klein)
Nachbearbeitung
Hardware
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen