Thingiverse
Doorstop Handle
por kirbby
2
Descargas
9
Likes
0
Makes
I couldn't find a door stopper for the door handle, so the door handle doesn't bang against the wall and made my own.
This should be printed with flexible material.
You might have to adjust the infill, I needed 3 tries to hit a good amount so its not too hard and not so soft that it will break on harder impacts.
It prints quite fast 20-30mins so you can try a few times without using too much material.
If you printed this and it worked for you let me know and post a make. Thanks!
This should be printed with flexible material.
You might have to adjust the infill, I needed 3 tries to hit a good amount so its not too hard and not so soft that it will break on harder impacts.
It prints quite fast 20-30mins so you can try a few times without using too much material.
If you printed this and it worked for you let me know and post a make. Thanks!
kirbby también publica en
21 modelos adicionales en 1 plataformas más
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
