Doraemon Fridge Magnet

注意！！！ 作者使用的是P1SC + AMS，所以本模型需要使用AMS 通过将部分颜色部件分离，达到仅需 28 分钟和不到 9g 的耗材就可以打印出可爱的哆啦小子了！如果批量生产出去摆摊，时间可以压缩到20分钟一个！ 材料：1、我使用的是拓竹的PETG-HF材料，也可以使用PLA（暂时没材料测试，所以没有相关打印配置，如果有大佬愿意分享那将感激涕零！！！）2、磁铁采用的是：两片直径10mm，厚度2mm的磁铁圆片，某宝有售卖价格便宜 建议胶水固定加固，红色鼻子需要大力压下去-------------------------------------------NOTE!!! The creator used a P1SC + AMS setup, so this model requires AMS to print!You can print this adorable Dora The Kid in just 28 minutes with under 9g of filament! Batch production could further reduce time to 20 minutes per piece - perfect for street stall sales!Materials:I used Bambu Lab PETG-HF filament. PLA is also acceptable (not yet tested, so no print profiles available. Contributions from experienced makers would be greatly appreciated!)Magnets: Two 10mm diameter × 2mm thickness circular magnets Recommend using glue for reinforcement after assembly.