Double Cap for USB Stick

Purchased a "Vansuny" brand USB & USB-C stick on amazon, but disliked how there was no way to keep the caps at-hand when the drive was in use. Designed this in Blender to overcome that problem!

There are three versions: one with a horizontal loop for a lanyard, one with a vertical loop, and one with no loop.

(When I imported the design into Cura, they ended up being twice as large as I'd wanted, so these have been resized appropriately... but if they end up weirdly small in your slicer, I would imagine just doubling the size would fix that.)

Make sure to print with supports.