Double Ender 3 Filament Guide

Thanks to MattEllison for a great idea, no screws, nuts or bolts just using the existing reel holder to secure it, I printed and used Matt's original and it was great until I put the reel up around the other way, hmm needed one on the other side as well and being just a little shorter is good for me, these guides also stop the possible reel tangle after a retract flies loose. I made sure it's secured with a tiny blob of hot melt glue on the right and left edges.
I made this by cut & shut in Orca Slicer!

Important update: I found an issue with this, if you print a model that asks the extruder to travel from one side of the bed to the other and you're using a full spool it could unhook a full loop of filament off the spool, causing a tangle, I'll think of something better, sorry.

Print Settings
Printer brand:
Creality

Printer:
Ender V3 SE

Rafts:
Doesn't Matter
Supports:
Doesn't Matter
Resolution:
.2mm

Infill:
20%

Note: If you can’t fit the guide over your spool holder, just file it