Thingiverse
Double finger pointed Knuckles
by DanGleebowls
0
Downloads
0
Likes
0
Makes
The finger stalls in this are 23mm Wide by 28mm Tall, this will print flat without supports and coming in at 15mm thick is nice and chunky, if you need to scale it up or down I would recommend changing the X and Y scaling by the same percentages, and leaving the Z scale at 100 percent.
Lots of people insist on printing at 100 percent infill for knuckles, but for PLA+, 5 walls, 5 top layers, and 5 bottom layers with 10 percent gyroid infill should do fine, these aren't supposed to break cinder blocks, punch bags with ill intent are softer than PLA+
This file is for a set of Printable knuckles intended for Prop use, be sure to use flexible filament or print as few perimeters and as little infill as possible while still maintaining the integrity of the print, so it is easy to prove they are a prop and not actual Knuckle Dusters. Especially if they are prohibited where you live.
Lots of people insist on printing at 100 percent infill for knuckles, but for PLA+, 5 walls, 5 top layers, and 5 bottom layers with 10 percent gyroid infill should do fine, these aren't supposed to break cinder blocks, punch bags with ill intent are softer than PLA+
This file is for a set of Printable knuckles intended for Prop use, be sure to use flexible filament or print as few perimeters and as little infill as possible while still maintaining the integrity of the print, so it is easy to prove they are a prop and not actual Knuckle Dusters. Especially if they are prohibited where you live.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!