Double Korg Volca Stand

I wanted to build a stand for two Korg Volcas to make playing both a little more comfortable. This is a very easy to print stand that requires no supports or any advanced printing techniques. Just lay each part flat and print it.

Parts breakdown for printing:

2x Side Board
2x Main Cross Brace
1x T Brace
1x Front Brace
1x L Brace

I apologize for overusing the term "brace".

See 2nd image for which parts go where.

Once printed you may have to sand down or trim around the slots depending on your print settings. This part is up to you. It is intentionally designed as a press fit assembly; however you could trim these down to make it easy to break down for storage or whatever.

This was printed with PETG on an (Ender) 3 V2 but I suspect most rigid filaments would do just fine. Please leave a comment with any issues.

I included an IGS file for modding. Cheers!