Thingiverse

Double Ledge for Fingerboards

von jrabu123

0 Downloads

1 Likes

0 Makes

Double ledge for fingerboards. 150g on 2% infill prints in 2h 30min on the bambu A1. A fun double ledge with coping. designed to be strong on low infill for cost and time efficiency. I tried to paint it grey but the paint was old and bad quality and it started to peel of. Please comment your suggestions for improvement.

double ledge fingerboard fingerboard ledge fingerboard rail fingerboard ramp fingerboard ramps fingerboarding fingerboarding equipment ledge

Quelle

Thingiverse

Was du zum Drucken brauchst: Mittel Niedrige Konfidenz

Einteilig

Supports 1/3

Zusammenbau 0/3

Einstellungen 1/3

Druckbett 0/3

Nachbearbeitung 1/3

Drucker

FDM / FFF

Dateiformat

STL

Material

Ca. Druckzeit

2 h

Nachbearbeitung

Bemalen

Software

Cura, PrusaSlicer o. Ä.

Noch keine Bewertungen

Noch keine Kommentare – sei der Erste!

Double Ledge for Fingerboards

Ähnliche Modelle

Zur Sammlung hinzufügen