Slicer Discord
double lithophane candle – 3D-Druckmodell von Thingiverse Thingiverse

double lithophane candle

von Guimly
32 Downloads
23 Likes
0 Makes
Zum Modell


suport for lithophanies 80x80x1.6 (round model) and 106.5x80x1.6mm with two hot candles.

To print the media put 25% of filling and at least 5 lines of borders. I tried to print in concentric mode for the pattern of the top / bottom and the result is really nice, I advise you. Set the support at 15 or 20% is enough.
I've also created a two-piece suport to make it easier to print, but print outs are more difficult to remove.

To print lithophanies of quality with Cura3 import photos directly in .jpg format.
In the dialog box that appears, enter the following parameters;
Height: 1.6
-Base: 0.2
-Width: 106.5
the darker is higher

the lithophanies printed in vertical have really a superior quality but implies to have a nozzle in 0.2 or to adjust the base to a minimum of 0.4 (diameter of the nozzle) which imputes very much the final rendering (transparency of the photos). I advise you to print horizontally if you have a nozzle in 0.4 and vertical if you have 0.2.
Before pri
Quelle
Thingiverse
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen