Thingiverse
Double Mac Arch/Stand
por Penguinwastaken
11
Descargas
10
Likes
0
Makes
The original ( https://www.thingiverse.com/thing:2135190 ) was perfect for my Mac, a little loose but that was fine. After I received my iPad, I needed a place for it. So I thought why not a double arch.
The original model was just doubled so that all proportions are included as in the original.
I use it with a MacBook Pro 2016, it sits a little loose but it's easy to take out.
The top opening is 18mm wide. At the widest point the arch is 39mm and in length 168mm.
For the best quality I aligned it as it would stand and turned on the supports everywhere (PrusaSlicer 2.3.0). With a slice height of 0.20mm, my Ender 3 v2 took about 4 hours. If I put it on its side and also print with supports then I come to just under 2.5 hrs, but the quality suffers in my opinion. Infill always at 25% but that's up to you, you just shouldn't go below 15%.
Have fun printing!
The original model was just doubled so that all proportions are included as in the original.
I use it with a MacBook Pro 2016, it sits a little loose but it's easy to take out.
The top opening is 18mm wide. At the widest point the arch is 39mm and in length 168mm.
For the best quality I aligned it as it would stand and turned on the supports everywhere (PrusaSlicer 2.3.0). With a slice height of 0.20mm, my Ender 3 v2 took about 4 hours. If I put it on its side and also print with supports then I come to just under 2.5 hrs, but the quality suffers in my opinion. Infill always at 25% but that's up to you, you just shouldn't go below 15%.
Have fun printing!
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
