Double Vertical Laptop Stand

Check out my single laptop stand of the same style: https://makerworld.com/en/models/1624837-single-vertical-laptop-stand#profileId-1715485 Double vertical laptop stand, specifically designed for an M1 Macbook air, and a 2024 Zephyrus G14. But it of course will fit laptops of similar sizes. The larger gap is 20.75 mm, and the smaller gap is 17 mm. If you need a little more or less room, scaling the pieces up and down shouldn't be an issue. I didn't use supports, but make sure your bridging settings are adequate for larger gaps. Or just enable supports. I also designed slots to insert TPU strips that have a slightly higher z height than the base, where the laptops rest. This just gives them a bit of cushion and grip. These will just snap into place. Same with the feet, TPU feet should just snap into place. I did not use glue for any of the TPU pieces.