Thingiverse
Double wall lamp fixture
door rhanton
0
Downloads
5
Likes
0
Makes
A wall fixture to hold a pair of bulbs, to be used with a pair of cheap threaded pendant E14 pendant holders.
The threading is designed to mate with cheap threaded pendant E14 light fixtures that can be purchased from Amazon and other retailers; unscrew the wires connecting it to the circular rose and screw the threaded portion into the fitting. For reference, the threading required is a pitch of 2mm.
Can be printed without supports. I printed it at 0.2mm resolution with 12% infill.
Bear in mind that PLA will droop if the temperature gets too high, so I'd recommend only using it with LED bulbs of a reasonable wattage, particularly if you are putting any kind of enclosure on the fitting that will reduce heat dissipation. Consider using a filament that remains stable at higher temperatures if your use-case will involve said temperatures.
The threading is designed to mate with cheap threaded pendant E14 light fixtures that can be purchased from Amazon and other retailers; unscrew the wires connecting it to the circular rose and screw the threaded portion into the fitting. For reference, the threading required is a pitch of 2mm.
Can be printed without supports. I printed it at 0.2mm resolution with 12% infill.
Bear in mind that PLA will droop if the temperature gets too high, so I'd recommend only using it with LED bulbs of a reasonable wattage, particularly if you are putting any kind of enclosure on the fitting that will reduce heat dissipation. Consider using a filament that remains stable at higher temperatures if your use-case will involve said temperatures.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
