Dovetail Phone Stand

di JamesThePrinter · Gadgets

351 Download

114 Likes

315 Makes

This phone stand uses a dovetail joint as a way to adjust the viewing angle. 0.2mm clearances were used in the dovetails. After sliding together a few times, the pieces will fit together nicely. This will work with phones and tablets in landscape or portrait positions. There is also plenty of room for devices with a case. Version 1 - Original design for use without a charger Version 2 - Modified for use with a charger For V1, no special settings are needed for printing. If printing V2 (charger), supports will be needed for the stand portion, but only inside the charger access hole. See below: Filaments used in photos above: MatterHackers Quantum PLA Green Raspberry Hatchbox PLA True Black

adjust adjustableendstop displaystand dovetail holder matterhackers matterhackersquantum phone phoneholder phonestand quantum smartphoneholder smartphonestand tablet tabletholder tabletstand

Categoria

Gadgets

Fonte

MakerWorld

Pubblicato

25.09.2023